What Are The Main Applications Of Wastewater Evaporators in The Industry

Main characteristics of wastewater evaporator:
The entire heating system of the equipment has the main characteristics of high heat transfer efficiency and short heating time due to uniform steam heating and liquid film flow evaporation. If equipped with a hot press pump, it will have advantages such as reduced consumption, low steam consumption, and low water circulation.
2. The material accelerates downward pressure flow and evaporation along the inner wall of the pipe, adapting to the evaporation and concentration of materials with high viscosity.
3. Due to the filmy evaporation of materials in each tube, the heating time of the material solution is very short, which is particularly beneficial for food evaporation and concentration, and greatly preserves the nutritional components of the food.
4. The evaporation process under vacuum not only ensures the hygiene requirements of the material, but also greatly reduces the evaporation temperature. In addition, with the configuration of a hot press pump, some secondary steam is sucked back into the hot press pump and mixed with the raw steam, saving the raw steam. At the same time, due to the steam passing through the hot press pump entering the heating shell in a spray like manner, the steam quickly diffuses and the material is heated gently, making it suitable for the concentration of thermosensitive materials.
5. The equipment is suitable for evaporation and concentration of foaming materials. Since the feed liquid evaporates in a film form in the heating tube, vapor liquid separation is formed. At the same time, at the bottom of the effect body, most of the feed liquid is pumped away. Only a small part of the feed liquid and all the secondary steam enter the separator to strengthen separation. The feed liquid does not form too much impact during the whole process, avoiding the formation of foam.
For food evaporation and concentration, reaching 94 degrees Celsius or above, maintain for about 24 seconds, and enter the first effect body. The material quickly flashes and the temperature drops instantly.